Toshiba Magnia Z300 - Manual (Page 116)

Installing and Removing Hardware
Internal battery 94
Internal battery
This server has an internal battery to store the information on a
timer and system configuration. The replacement of a battery
requires special technology and knowledge. Toshiba recommends
that you ask your authorized MAGNIA service provider to replace
the internal battery.
CAUTION: Observe the following when handling a lithium
battery.
A lithium battery is used for the internal battery of the server.
Be careful not to handle it incorrectly. This may cause heat
generation, explosion, or fire.
Do not charge and disassemble a lithium battery and elimi-
nate its electrode.
Do not heat and burn a lithium battery at 100°C or higher.
Do not allow battery to get wet.
Keep out of reach from children.
Ultimate disposal of lithium batteries should be handled
according to all national laws and regulations.
Install the polarity (+ and -) of a battery correctly.
Replace it only with the same or equivalent type recom-
mended by the manufacturer.
If not so, heat generation, explosion, or fire may be caused.
NOTE: System configuration information (set during setup) is
lost when a battery is removed. After the battery is replaced,
set again according to the system configuration information.
The internal battery that can be used for this server is a com-
mercial CR2032 lithium battery.