Toshiba Magnia Z300 - Manual (Page 266)

244
ALARM (71)
Ex. Device Bay2 +5.0V low. Low voltage error of External Device Bay Unit 2+5.0V power
supply.
ALARM (72)
Ex. Device Bay2 +5.0V high. High voltage error of External Device Bay Unit 2+5.0V power
supply.
ALARM (73)
Ex. Device Bay2 +12.0V low. Low voltage error of External Device Bay Unit 2+12.0V power
supply.
ALARM (74)
Ex. Device Bay2 +12.0V high. High voltage error of External Device Bay Unit 2+12.0V power
supply.
ALARM (75)
Ex. Device Bay2 FAN1 RPM slow. The External Device Bay Unit 2 fan 1 slow rpm error has
occurred.
ALARM (76)
Ex. Device Bay2 AC lost. Power interruption reset was detected on External Device Bay
Unit 2.
ALARM (77)
Ex. Device Bay2 power sag. Momentary power interruption was detected on External Device
Bay Unit 2.
ALARM (78)
Ex. Device Bay2 power supply fault. The External Device Bay Unit 2 fuse has blown.
ALARM (79)
Ex. Device Bay2 temp high. The External Device Bay 2 high temperature error has occurred.
ALARM (80)
Ex. Device Bay2 fuse blow out. The External Device Bay 2 fuse has blown.
ALARM (87)
Internal HDD error. An internal HDD error has occurred.
ALARM (88)
Memory error in BIOS POST. Resized. Memory error has occurred. Memory has been reduced.
ALARM (89)
Correctable memory ECC error. Correctable error has occurred.
ALARM (90)
Uncorrectable memory ECC error. Uncorrectable error has occurred.
ALARM (91)
Critical interrupt (NMI) occurred. Fatal error (SMI) has occurred.
ALARM (92)
Critical interrupt (SMI) occurred. Fatal error (NMI) has occurred.
ALARM (93)
Critical interrupt (PERR) occurred. Fatal error (PERR) has occurred.
ALARM (94)
Critical interrupt (SERR) occurred. Fatal error (SERR) has occurred.
ALARM (95)
No boot device. Cannot find boot device.
Display Meaning of Message