Toshiba Magnia Z300 - Manual (Page 120)

Installing and Removing Hardware
Hard Disk Drive (HDD) –IDE HDD– 98
Hard Disk Drive (HDD) –IDE HDD–
Slot numbers (of 1 to 2 from bottom) are assigned to each slot of a
hard disk drive.
Installing the hard disk drive
NOTE: The installation and replacement of a hard disk drive
requires special technology or knowledge. If you have no
experience in installing a hard disk drive or if you need assis-
tance, consult your authorized MAGNIA service provider.
An error in the installation procedure may damage the server
or destroy it, and you may lose important programs or data.
Install the hard disk drive in the procedure described below, while
referring to “Before starting operation” on page 48
1 If the server is running, shut it down and switch off the power.
2 Unplug the power cable.
3 Remove the front panel.
See “Front panel” on page 11
4 Tilt over the detachable lever of the slot where you want to
install a hard disk drive, by pulling its knob toward you.
Pulling the detachable lever toward you