Konica Minolta BIZHUB C30P - Manual (Page 137)

MetaConsole 2.3 including PageScope EMS Plug-Ins
page 123
Output Options Page
The Output Options page provides the user with specific information about the selected de-
vice’s engine.
To access this page, follow this procedure:
1 In the Tree Pane, expand the device’s node. Expand the Component node then click the
Engine Information node to expand it.
2 Click the Output Options icon. The following page will open in the right pane (Figure 3.7).
Figure 3.7: Output Options Page
Output Information
This Output Information page contains the following information:
• Finisher Installed: If a Finisher is installed, Yes appears; if not, No appears here
• Finisher Model: If a Finisher is installed, its Model number appears here
• Finishing Offset Mode: If the Offset Mode is enabled, On appears; if not,Off appears here
• Finishing Collate Mode: If the Collate Mode is enabled, On appears; if not,Off appears
here
• Finishing Staple Mode: If the Staple Mode is enabled, On appears; if not,Off appears
here
• Number of Output Bins: The number of Output Bins appears here