Konica Minolta BIZHUB C30P - Manual (Page 106)

Configuring MetaConsole
page 92
Specifying Pager Notification Settings
To specify settings for pager notification, follow this procedure:
1 In the navigation pane, expand the Configuration node and click Alarm Notification
Methods. The Alarm Notification Methods screen opens (Figure 2.31).
2 Click the Settings . . . button next to the Pager check box. The Pager Notification Set-
tings appear at the bottom of the details pane (Figure 2.33).
Figure 2.33: Unicenter Pager Notification Settings
3 Specify primary recipients by doing one or both of the following:
• To add a recipient to the Pager List:
a. In the Pager ID box, type a pager ID (typically a 10- or 11-digit phone number).
b. In the Pager Service list, click the name of the paging service to be used.
c. Click the adjacent Add button.
• To remove a recipient from the Pager List: Click the pager ID; then click the adjacent
Remove button.
4 In the From box, type the name that will appear as the originator of all alarm page mes-
sages sent by MetaConsole. Typically, this is a network administrator’s name.
5 In the Subject box, type the text that will appear in the Subject field of all page messages
sent by MetaConsole. Typically, this text should indicate the type of message (e.g., Device
Alert).