Konica Minolta bizhub C650 - Manual (Page 268)

C650 10-9
Reports and Lists 10
10.4 Broadcast Report
Broadcast Report is printed automatically when sequential broadcast transmission is completed.
"ON/OFF" can be set in [Sequential TX Report] of the Utility mode. Report output timing (all destinations/each
destinations) can be specified in [Broadcast Result Report].
2
Note
For details on [Sequential TX Report] and [Broadcast Result Report], refer to "Specifying Report Printing
Methods (Report Setting)" on page 9-65.
Destination: Any of the following is described.
- Name registered with the destination in the Address Book or in the program
- Recipient’s destination
Start Time: Describes the start time of the communication.
Time: Fixed in "--:--:--".
Prints: Describes the number of pages sent. The sent pages and the total number of pages are described in
fractional format.
Result:
Remarks: Describes one of the following in the Network fax description.
OK Described when communication is terminated normally.
S-OK Described when communication has stopped.
PW-OFF Described when operation power switch was turned OFF during communication.
TEL Described when there is telephone call.
NG Described when there is communication error.
Cont Described when there is a transmission error and that there is transition to resend wait
mode (Error page redial).
No Ans Described when there is no response from the recipient.
Busy Described when communication is not possible as the recipient’s line is busy.
MDN Described when there is error in MDN response.
DSN Described when there is error in DSN response.
ORG Original size specification
MIX Mixed Original transmission
SP Special Original
IP ADR IP address fax
I-FAX Internet fax
FME Frame Erase transmission
BND Binding Position