Konica Minolta bizhub 20 - Manual (Page 207)

199
11
11
If you want to scan from the machine on a network, you must choose the networked machine in the
Device Selector application located in Macintosh HD/Library/Printers/KONICA
MINOLTA/Utilities/DeviceSelector or from the Model pop-up menu in the main screen of ControlCenter2.
If you already installed the Multi-Function Suite Software following the network installation steps in the Quick
Guide then this selection should already be made.
To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can
set or change the address settings from the control panel. (See Control Panel Setup in the Network User’s
Guide.)
Note
For network scanning, a maximum 25 of clients can be connected to one machine on a network. For
example, if 30 clients try to connect at a time, 5 clients will not be shown on the LCD.
Before using Network Scanning
11
Configuring network scanning
11
a From Library, choose Printers, KONICA MINOLTA, Utilities and DeviceSelector, and then double-
click Device Selector.
The Device Selector window appears. This window can also be opened from ControlCenter2.
For more information, see Using ControlCenter2 on page 179.
b
Specify your machine by IP address or mDNS service Name. To change the IP address, enter the new
IP address. You can also choose a machine from the list of the available machines. Click Browse to
show the list.
c
Click OK.
Network Scanning
11