Konica Minolta BIZHUB C360 - Manual (Page 155)

bizhub C360/C280/C220 7-18
7.1 [System Settings] 7
7.1.9 [Reset Settings]
Configure auto reset settings.
0 All settings performed in the following tabs during operation using the copy function are automatically
reset to the initial settings after the specified time has elapsed.
[Basic], [Original Setting], [Quality/Density], [Application]
0 Even if [OFF] is selected for System Auto Reset Time, the system auto reset function operates when
this machine is not used for one minute during user authentication/account track operations.
%
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Reset Settings].
Factory default
[Job Settings List] • [1-Sided]
• Tray 1
Settings
[System Auto Reset] [Priority Mode] Configure a mode to be displayed in the system
auto reset mode.
[System Auto Reset
Time] Configure whether to perform system auto reset.
Specify a time until the initial screen appears if
this machine is not operated. The specified time
is not canceled.
d
Reference
If user authentication or enhanced se-
curity mode is enabled, the adminis-
trator settings mode or user
authentication mode is logged off ac-
cording to the setting for System Auto
Reset Time.
In the enlarge display mode, the sys-
tem auto reset mode is disabled.
[Auto Reset] Configure whether to perform auto reset in the selected mode.
Specify a time until the basic settings screen appears and the settings are
reset to the initial values if this machine is not operated.
[Job Reset] [When Account is
changed] Configure whether to reset the settings when you
log off if the user authentication or account track
settings have been configured.
[When original is set
on ADF] Configure whether to reset the settings when an
original is loaded in the ADF.
[Next Job] Configure whether to reset the following settings
when the next job is selected.
•
[Staple Setting]
• [Original Set/Bind Direction]
• [Reset Data After Job]
The destination of data is always reset.