RADWAG PUE C41H Indicator - Manual (Page 106)

Caution:
If dosing is initiated when the indication is > LO , after reaching the
indication below LO output (outputs)will be automatically switched
on. Subsequent dosing process can be started when indication
goes below LO.
24.8.5. Tarring mode setting
The parameter allows to enable/disable automatic
tarring in DOSING mode.
Procedure:
• Enter
and then:
Return to weighing:
See 11.3.
24.8.6. Corrections
Work mode can have automatically corrected nominal mass
in the dosing procedure that allows to optimize the procedure considering
pressure changes of dosed substance in the hopper or other container.
In parameters’ group users can set
parameters that refer to introducing mass correction.
- 106 -