WIKA CF1H - Manual (Page 9)

Operating Instructions Temperature Indicating Controller CF1H
V 1.2
•
01/2007 - 9 -
3. Setup
3.1 Taking the internal assembly out
Before the power supplied to this instrument is on, take the internal assembly out from
the case by pushing the hook (bottom of the instrument) in the direction indicated by
the arrow and holding the notches.
[Fig.
3.1-1]
Warning
Do not take the inner assembly out nor touch the terminal with
the power supply on
.
Touching the terminal with the power switched ON may result in
Electric Shock, which can cause severe injury or death.
3.2 Switch setting (multi-function)
Using a small slotted screwdriver and tweezers, set the Sensor input, Alarm 1 action, Alarm 2 action,
Control action, Heating (reverse)/Cooling (direct) action, Alarm 1 and 2 standby functions, Unit °C/°F and
Program starting form Auto/Manual change by rotary switch and DIP switch by the following procedure.
If the option A2 is not applied, the rotary switch A2 (SW301) will not be equipped.
Control action designation Alarm 2 action type designation
Heating/Cooling action designation Alarm 1 action type designation
Alarm 1 standby action designation Sensor input designation
Alarm 2 standby action designation
°C/°F designation
Sensor input designation
Program start Auto/Manual
designation
[Fig.
3.2-1]
DIP switch
Rotary switch