WIKA CF1H - Manual (Page 24)

Operating Instructions Temperature Indicating Controller CF1H
V 1.2
•
01/2007 - 24 -
Sensor correction function
Corrects the input value from the sensor. When a sensor cannot be set at a location
where control is desired, the sensor measuring temperature may deviate from the
temperature in the controlled location. When controlling with multiple controllers,
the accuracy of sensors have influence on the control. Therefore, sometimes the
measuring temperature (input value) does not concur with the same setting value.
In such a case, the control can be set with desired temperature by shifting the input
value of sensors.
Overlap band/Dead band Mode to set the Overlap band and Dead band
setting between Heating control output and Cooling control output.
Setting value
+ setting value: Dead band
MODE – setting value : Overlap band
Setting range: ± Heating proportional band
converted value
[Factory adjusted as 0.0 %, Indication: °C]
When the option [D 2] is not applied, or if setting the control
action as ON/OFF, this display is not available.
Remote/Local changing Mode to change the method (Remote or Local)
Method to set the Main setting value.
MODE [Factory adjusted as Local]
Local status. The main setting value can be set
by the front key operation as usual.
Remote status. The main setting value can be
set in analog value by the remote control from external operation.
This display is available only when the option
[EA or EV ] is applied.
Instrument number setting Mode to set the Instrument number individually
Setting value to each instrument when communicating by
connecting plural instruments in serial communication.
MODE
Setting range: 0 … 95 [Factory adjusted as 0]
This display is available only when the option [CR2 or CR5]
is applied.