AMD SimNow Simulator 4.4.4 - Manual (Page 251)

AMD Confidential
User Manual September 12
th
, 2008
Appendix A 239
DMALogStatus
Returns „enabled‟ if logging is enabled otherwise it
returns „disabled‟.
A.7.12 8
th
Generation Northbridge
1 simnow> sledgenb.usage
Automation Command Description
LogHT (0|1) Enables (1) or disables (0) logging.
HTLogStatus
Returns „enabled‟ if logging is enabled otherwise it
returns „disabled‟.
LogPCIConfig (0|1) Enables (1) or disables (0) PCI Config logging.
PCILogStatus
Returns „enabled‟ if PCI Config logging is enabled
otherwise it returns „disabled‟.
GetConfig Displays Northbridge logging configuration.
ProductFile
Loads the specified product file “FileName”.
A.7.13 DBC
1 simnow> dbc.usage
Automation Command Description
GetParam
Returns disk block cache parameters (size, depth and
bits).
SetParam Sets disk block cache parameters.
A.7.14 AMD-8111
™ Device
1 simnow> 8111.usage
Automation Command Description
BaseID (00|01)
This specifies the HyperTransport™ protocol base unit
ID. The IC's logic uses this value to determine the unit
IDs for HyperTransport request and response packets.
The Base ID must be 00 or 01.
GetBaseID Returns the HyperTransport base unit ID (BUID).
HtInterrupts (0|1) Enables (1) or disables (0) HyperTransport interrupts.
HtIntStatus
Returns „enabled‟ if HyperTransport interrupts are
enabled; otherwise it returns „disabled‟.
IoLog (0|1) Enables (1) or disables (0) IO logging.
IoLogStatus
Returns „enabled‟ if IO Logging is enabled; otherwise it
returns „disabled‟.
MemLog (0|1) Enables (1) or disables (0) IO logging.
MemLogStatus
Returns „enabled‟ if Memory Logging is enabled;
otherwise it returns „disabled‟.
SmiSciLog (0|1) Enables (1) or disables (0) IO logging.
SmiSciLogStatus
Returns „enabled‟ if SMI SCI Logging is enabled;
otherwise it returns „disabled‟.