Hawk Industries Hawkjaw Sr. Manual ALS Serial Numbers 1 to 100 - Manual (Page 52)

2. Use the 3/4" wrench to remove
all Bearing Cap Bolts (47).
3. Remove the Bearing Caps (1)
and Bearing Seals (29).
4. Slide out the Drive Roller
Sprockets (2).
5. Remove the Drive Roller Snap
Rings (27).
6. Remove the Drive Rollers (11)
and Keys (9).
7. Slide on the new Drive Rollers
and replace the Keys (9).
8. Replace the Drive Roller Snap
Rings (27).
9. Slide in the Drive Roller
Sprockets (2) . Make sure the
"T" on each Drive Roller
Sprocket faces up.
10. Replace the Bearing Caps (1)
and Bearing Seals (29).
11. Use the 3/4" wrench to replace
all Bearing Cap Bolts (47). Use
new Lock Washers (41) and red
loctite when replacing the
Bearing Cap Bolts (47).
Assemble the Lock Washers
(41) as shown. Torque Bearing
Cap Bolts (47) to 75 lb. ft.
Changing the Drive Rollers (cont.)
Part Numbers
Part Name Part #
Bearing Cap Bolt (47) 999-806373
Lock Washers (41)
031-91074A033
Drive Roller (11) 031-24649
Bearing Seal (29) 031-24649
WARNING
Replace all four Drive Rollers.
Running the Spinner with worn
Drive Rollers will damage the
chain and hinder Spinner
performance.
52 Maintenance & Repair