Hawk Industries Hawkjaw Sr. Manual ALS Serial Numbers 1 to 100 - Manual (Page 44)

Lubricant Required
Chevron Pinion Grease Spray
(Part # MS-SP), 7/16" wrench
Spinner Maintenance
1. Connect the air and hydraulic
power units to the HawkJaw.
See Operation, p. 14.
2. Use the 7/16" wrench to remove
the rubber Safety shield bolts
(B).
3. Remove rubber Safety shield
(S).
4. While spinning after break out,
from the back of the spinner,
apply spray to chain.
5. Replace rubber Safety shield
(S).
6. Use the 7/16" wrench to replace
the rubber Safety shield bolts
(B).
Grease Once per Week
Chain
44 Maintenance & Repair
S
B
WARNING
Never under any conditions apply
weight materials or any other dry
materials to the chain.
WARNING
Run spinner only when gripped on
a pipe body.
WARNING
Keep hands away from the main
drive sprocket while spraying the
chain.