Hawk Industries Hawkjaw Sr. Manual ALS Serial Numbers 1 to 100 - Manual (Page 16)

Winch Hook - Up (cont.)
16 Installation
10. Disengage the Winch Clutch
(C). Spool out enough line to
anchor the Winch Tie-Back
Hook (H) to a structural point on
the derrick.
11. Anchor the Winch Tie-Back
Hook (H) to a structural point on
the derrick. Make sure there is
enough slack in the line to enable
the HawkJaw to move onto the
drill pipe connection.
12. Engage the Winch Clutch (C).
13. Use Winch Off (WOff) to pull
the HawkJaw 3' to 5' ft. away
from the wellbore. This allows
the drill pipe stands to swing
straight from pick-up to
stabbing.
C
H
WOff