ARRI ARRIFLEX 235 - Manual (Page 65)

65 65
Mode 5
Changing the Run up Speed:
In menu 5 the run up speed can be changed in two steps.
The faster run up speed uses less film, but sometimes when
Steadicams or a very long power cable is used a longer run
up time is easier on the batteries.
• Depress the “SEL“-key until the desired run up speed
blinks.
• Select the desired run up speed by pressing the “SEL”-
button.
setting ramping speed
LO 25f/s 2
HI 40f/s 2
Displaying software versions
• Press “SET“ for three seconds in the rampspeed menu:
the first line will display Sxx.xx for the camera software
version.
The second line will display Fxx.xx for the FPGA
software version
• Press “SEL“: the first line will display bxx.xx for the
bootloader software version.
The second line will display Pxx.xx for the software
version.
Camera Operation