ARRI ARRIFLEX 235 - Manual (Page 152)

152 152
Magazine
Cleaning the Throat Assembly
The throat assembly ➪
photo can be disassembled for
cleaning.
• Loosen the three screws
➪
photo on the throat
assembly cover ➪
photo .
• Remove the holder plate ➪
photo for the loop
protector.
• Pull out the throat assembly cover.
• Clean the film running surfaces
➪
photo and guide
rollers ➪
photo with a brush.
• Put the throat assembly cover back in place.
• Replace the holder plate for the loop protector and re-
tighten the throat assembly cover with the three screws.
Setting Friction on the Shoulder Magazine
• Swing the roller arm ➪ photo away from the winding
shaft until it locks in place.
• Unscrew the three screws on the transparent tensioning
plate ➪ photo .
• Remove the plate.
• Place a film core on the take-up side.
• Place the core adapter ➪
photo on the feed-side.
• Place the tension measurement device ➪ photo on the
core adapter on the feed side.
screws
holder plate guide rollers
running surfaces Maintenance