ARRI ARRIFLEX 235 - Manual (Page 63)

63 63
Displaying the Power Supply Voltage (Mode 3)
• Change from Mode 1 to Mode 3 by depressing the
“MODE”-button twice. The power supply voltage is
shown in the lower line of the display.
Setting the brightness of the button illumination
• Change from Mode 1 to Mode 4 by depressing the
“MODE”-button three times.
• Depress the “SEL”-button three times to activate the
display for setting the button illumination.
• Select the desired brightness using the “SET”-button.
0…off
3…maximum brightness
Camera Operation