Allied Telesis OmniConnect ISDN - Manual (Page 77)

OmniConnect / ISDN User’s Manual Page 71
Part number 613-10787-00
Cause
Value
Hex
Value
Cause Message Definition
18 0x12 No User
Responding
The connection cannot be completed because
the destination does not respond to the call.
19 0x13 No Answer from
User
The destination responds to the connection
request, but fails to complete the connection
within the prescribed time. The problem is at
the remote end of the connection.
21 0x15 Call Rejected The destination is capable of accepting the
call, but rejected the call for an unknown
reason.
22 0x16 Number Changed The ISDN number used to set up the call is
not assigned to any system.
26 0x1A Non-selected User
Clearing
The destination was capable of accepting the
call, but rejected the call because it was not
assigned to the user.
27 0x1B Destination Out of
Order
The destination cannot be reached because the
interface is not functioning correctly, and a
signaling message cannot be delivered. For
example, the remote equipment might be
turned off.
28 0x1C Invalid Number
Format
The connection could not be established
because the destination address was presented
in an unrecognizable format.
29 0x1D Facility Rejected The network cannot provide the facility
requested by the user. This is common if, for
example, an analog call is being attempted and
the user for the ISDN line has not provisioned
ACO (Additional Call Offering).
30 0x1E Response to
Status Inquiry
The status message was generated in direct
response to the receipt of a status inquiry
message
31 0x1F Normal,
Unspecified
Reports the occurrence of a normal event
when no standard cause code applies.
34 0x22 No Circuit
Available
The connection cannot be established because
no appropriate channel is available to take the
call.
38 0x26 Network Out of
Order
The destination cannot be reached because the
network is not functioning correctly, and the
condition might last for an extended period of
time. An immediate reconnect attempt will
probably be unsuccessful.