Allied Telesis OmniConnect ISDN - Manual (Page 45)

OmniConnect / ISDN User’s Manual Page 39
Part number 613-10787-00
5.4.9. ISDN Add phone number
The ISDN Add Phone Number screen is used to add a Caller ID phone number. When an
incoming phone call with the phone number entered on the ISDN Add Phone Number screen
is detected, the Extension Number, Ring Type and Call Forwarding parameters set in this
screen are used.
Enter the phone number of the person to be
tracked in the Phone Number dialog box.
Enter a descriptive term (e.g., Mother) in
the dialog box marked Description. This
description will be used by the
OmniConnect Monitor application to
display this incoming call information.
Next, choose the Extension Number to be
rung when the Caller ID information from
the incoming call matches the phone
number. (For the OmniConnect/ISDN, this
will always be 1, since there is only 1
POTS line).
Choose a RING Type from the selection in the pick list. The options are:
•
Normal – Standard United States ring – 2 seconds on 4 seconds off
•
Personal – Standard European Ring – 0.8 seconds on, 0.4 seconds off, 0.8
seconds on, 4 seconds off
•
Urgent - 0.8 seconds on, 0.4 seconds off, 0.8 seconds on – repeats
•
Off – No ring
Lastly, determine whether this call is to be forwarded or not. If the call is to be forwarded,
choose either Send All or After 4 Rings. In the case of Send All, all incoming calls from this
caller ID will be forwarded immediately. In such cases, the phone will briefly ring, but the
user will be unable to pick up the phone. In the case of After 4 Rings, the call will be
forwarded to the number specified in Forward Destination after four rings.
Note: The complete phone number including any international or long distance prefixes
must be entered in this field.
Once you have finished entering the information, click Next> to advance to the next screen.