Allied Telesis AT-S41 - Manual (Page 99)

AT-S41 User’s Guide
99
However, it is important to note that, by default, all of the ports that
you just added to the new VLAN are tagged ports, meaning they are
shared ports. The ports are still members of their current VLANs.
If you want to convert the ports into untagged ports, you must
perform the procedure in Phase 2.
Phase 2 This phase of creating a new VLAN converts the tagged ports that you
added to the new VLAN into untagged ports. This involves changing the
PVIDs of the ports so that they match the VID of the new VLAN. For
example, if you assigned the new VLAN a VID of 4, you must change the
PVIDs of the untagged ports to 4. The following procedure explains how
this is accomplished.
The following procedure assumes that you are continuing directly from
Phase 1.
1. From the VLAN Creation Menu, type Q to select Quit to Previous
Menu.
The VLAN Management Menu is displayed again.
2. Type S to select Set Port Config.
The VLAN Port Configuration Menu is displayed in Figure 26.
Figure 26 VLAN Port Configuration Menu
AT-8326GB Local Management System
VLAN Management -> VLAN Port Configuration Menu
Stack ID: 1
Port PVID
---- ----
1 1
2 1
3 1
4 1
5 1
6 1
7 1
8 1
-------------------------------- -----------------------
[N]ext page Set Port [V]ID
[P]revious Page Set Stack [I]D
[Q]uit to previous menu
Command> _
Enter the character in square brackets to select option