Allied Telesis AT-S41 - Manual (Page 203)

AT-S41 User’s Guide
203
Viewing or Modifying a Tagged or Untagged VLAN
There are two phases to modifying a VLAN. You might need to perform
both phases or just one, depending on what it is you want to change in
the VLAN. The phases are:
❑ Phase 1: In this phase, you can view a VLAN’s configuration, as well
as change a VLAN’s name and add or remove tagged ports.
❑ Phase 2: In this phase, you can add or remove untagged ports.
Phase 1 This phase explains how to display the Config VLAN Member Menu of a
VLAN. You can use the page to view a VLAN’s configuration as well as
change a VLAN’s name and add or remove tagged ports.
Note
If you do not want to change a VLAN’s name or add or remove
tagged ports, then skip this procedure and go straight to Phase 2 to
add or remove untagged ports.
1. Click on the Advanced Config menu tab and select VLAN Config from
the sub-menu. Select VLAN Info from the next sub-menu.
The VLAN Information will appear, as displayed in Figure 69
Figure 69 VLAN Information (802.1Q VLANs)
This page lists all of the VLANs that currently exist in the stack.
2. To view a VLAN’s configuration or to make changes to a VLAN, click
the Modify link in the right column for the VLAN you want to view or
modify.