Allied Telesis AT-S41 - Manual (Page 55)

AT-S41 User’s Guide
55
Possible values are:
Enabled - The port is allowed to use flow control. This is the
default setting for all of the ports on the stack.
Disabled - The port is not configured to use flow control.
Port status, mode, and flow control can be configured from the
Port Configuration Menu.
3. To configure port status, type S to select the Set Status option.
The following prompt is displayed:
Set Status-> Enter port number>
Port number is in range of 1 to 26, 0 to set all
ports.(Except giga port)
Enter a port number. Press Enter and type E for Enable or D for
Disable. The new port status is activated immediately and
displayed in the Port Configuration Menu.
4. To configure port mode, type M to select the Set Mode option.
The following prompt is displayed:
Set Mode-> Enter port number>
Port number is in range of 1 to 26, 0 to set all
ports.(Except giga port)
Enter a port number.
The following prompt is displayed:
Enter new mode for port 3 (a/h/H/f/F)>
a:Auto; h:10-HDx; H:100-HDx; f:10-FDx; F:100-FDx
(case sensitive)
Enter the new operating mode for the port and press Enter. The
new port mode is activated immediately and displayed in the Port
Configuration Menu.
5. To configure flow control, type F to select the Set Flow Control option.
The following prompt is displayed:
Set flow control-> Enter port number>
Port number is in range of 1 to 26, 0 to set all
ports.(Except giga port)
Enter a port number. Press Enter and type E for Enable or D for
Disable. The new flow control setting is activated immediately
and displayed in the Port Configuration Menu.