Allied Telesis AT-S41 - Manual (Page 36)

AT-S41 User’s Guide
36
Configuring System Administration Information
The procedure in this section explains how to assign a name to the
switch, along with other optional information, such as the name of the
administrator responsible for maintaining the unit and the location of
the AT-8326GB stack.
To set a stack’s administration information, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, select A for System
Administration Configuration.
The System Admin. Configuration Menu is displayed in Figure 4.
Figure 5 System Admin. Configuration Menu
3. Change the parameters as desired. To change a parameter, type the
bracketed letter in the corresponding command and, when
prompted, enter the new information.
The commands for changing the parameters in the System
Administration Configuration Menu are described below:
Set System [N]ame
This command specifies a name for the stack (for example, Sales).
This parameter is optional and may contain up to 50 characters.
AT-8326GB Local Management System
Basic Switch Configuration -> System Admin. Configuration
Menu
Description: AT-8326GB
Object ID: 1.3.6.1.4.1.207.1.4.52
Name:
Location:
Contact:
--------------------------- ---------------------
Set System [N]ame
Set System [L]ocation
Set System [C]ontact Information
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option