Allied Telesis AT-S41 - Manual (Page 77)

AT-S41 User’s Guide
77
Modifying Port Monitoring
To modify the port monitoring configuration, perform the following
procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
2. From the Advanced Switch Configuration Menu, type M to select Port
Monitoring Configuration.
The Port Monitoring Configuration Menu is displayed, as shown in
in Figure 21.
3. To change the monitoring port, type S to select Set Monitoring Port.
The following prompt is displayed:
Set monitoring port->Enter port number>
4. Enter the number of the port you want to function as the monitoring
port. You can specify only one monitor port. Press Enter.
The port number you have just entered is displayed under the
Monitoring Port heading on the Port Monitoring Configuration
Menu instead of the previous monitoring port’s number.
5. To change the monitored port, type M to select Set Monitored Port.
The following prompt is displayed:
Set monitored port->Enter port number>
6. Enter the number of the port whose traffic is to be monitored. You can
specify only one port to be monitored. Press Enter.
The port number you have just entered is displayed under the
Monitored Port heading on the Port Monitoring Configuration
Menu instead of the previously monitored port’s number.
7. Type E to select Enable/Disable Port Monitoring.
The following prompt is displayed.
Enable or Disable monitoring (E/D)>
8. Type E to enable port monitoring. The status will change to Enabled
on the Port Monitoring Configuration Menu.
Note
If you change either the monitoring port or the monitored port, the
port monitoring function will reset itself to Disabled. You must
Enable port monitoring each time you make a change to the port
monitoring configuration.