Allied Telesis AT-S41 - Manual (Page 101)

AT-S41 User’s Guide
101
Viewing or Modifying a Tagged or Untagged VLAN
There are two phases to modifying a VLAN. You might need to perform
both phases or just one of them, depending on what it is you want to
change in the VLAN. The phases are:
❑ Phase 1: In this phase, you can view a VLAN’s configuration, as well
as change a VLAN’s name and add or remove tagged ports.
❑ Phase 2: In this phase, you can add or remove untagged ports.
Phase 1 This phase explains how to display the Config VLAN Member Menu of a
VLAN. This menu displays a VLAN’s configuration. You can also use the
menu to change a VLAN’s name and add or remove tagged ports.
Note
If you do not want to change a VLAN’s name or add or remove
tagged ports, then skip this procedure and go straight to Phase 2 to
add and remove untagged ports.
1. From the Main Menu, type A to select the Advanced Switch
Configuration Menu.
2. From the Advanced Switch Configuration Menu, type V to select
VLAN Management.
3. From the VLAN Management Menu, select O for the Config VLAN
Member option.
The following prompt is displayed:
Enter VLAN ID>
4. Enter the VID of the VLAN you want to view or modify.