Allied Telesis AT-S41 - Manual (Page 44)

AT-S41 User’s Guide
44
Resetting the Management Software Default Values
The procedure in this section returns all management parameters in a
stack to their default values. This procedure also deletes any VLANs that
you have created in the stack.
Note
The management software default values can be found in
Appendix A on page 235.
To return the management software to its default settings, perform the
following procedure:
1. From the Main Menu, type T to select Switch Tools.
2. From the Switch Tools Configuration Menu, type R to select System
Reboot.
The System Reboot Menu is displayed in Figure 8.
Figure 8 System Reboot Menu
3. From the System Reboot Menu, type O and then select Factory
Default.
4. Type R to Start Reboot Process.
The following prompt is displayed:
Are you sure you want to reboot the system (Y/N) ->
5. Type Y for yes or N for no.
If you type Y for yes, the stack settings are reset to the factory
default values.
AT-8326GB Local Management System
Main Menu -> System Reboot Menu
Reboot Status: Stop
Reboot Type: Normal
------------------------- ---------------------
Set Reboot [O]ption
Start [R]eboot Process
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option