Allied Telesis AT-9724TS - Manual (Page 84)

Figure 6- 70.Access Rule Table (Packet Content Mask)
To remove a previously created rule, select it and click the button.To add a new Access Rule, click the Add button:
Figure 6- 71.Access Rule Configuration – Packet Content Mask
To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply.
Parameter Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according
to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the Switch and
will be filtered.
Access ID Type in a unique identifier number for this access.This value can be set from 1 - 50.
Type Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
83 Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch