Allied Telesis AT-9724TS - Manual (Page 172)

The user may search the IGMP Snooping Forwarding Table by VLAN Name using the top left hand corner Search.
The following fields can be viewed:
Parameter Description
VLAN Name The VLAN Name of the multicast group.
Source IP The Source IP address of the multicast group.
Multicast Group The IP address of the multicast group.
Port Map These are the ports where the IP multicast packets are being forwarded to.
9-10 Browse Router Port
This displays which of the Switch’s ports are currently configured as router ports.A router port configured by a user (using the console or Web-based
management interfaces) is displayed as a static router port, designated by S.A router port that is dynamically configured by the Switch is designated by D.
Figure 9- 21. Browse Router Port window
9-11 Port Access Control
The following screens are used to monitor 802.1x statistics of the Switch, on a per port basis.To view the Port Access Control screens, open the monitoring
folder and click the Port Access Control folder.There are six screens to monitor.
Note: 802.1X must be enabled under Configuration > Advanced Settings.
Authenticator State
The following section describes the 802.1X Status on the Switch.To view the Authenticator State, click Monitoring > Port Access Control >
Authenticator State.
Figure 9- 22.Authenticator State window – Port Based 802.1x
171 Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch