Allied Telesis AT-S63 - Manual (Page 840)

Chapter 36: TACACS+ and RADIUS Protocols
840 Section VIII: Management Security
Configuring RADIUS
To configure the RADIUS protocol, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Configuration menu is shown in Figure 282 on
page 834.
3. Type 4 to select RADIUS Configuration.
The RADIUS Client Configuration menu is shown in Figure 285.
Figure 285. RADIUS Client Configuration
4. Adjust the following parameters as necessary.
Global Encryption Key
This parameter specifies the encryption key for the RADIUS servers.
This option is useful if you will be entering more than one RADIUS
server and all the servers share the same encryption key. The
maximum length is 39 characters. The default is ATI.
Global Server Timeout period
This parameter specifies the maximum amount of time the switch waits
for a response from a RADIUS server before assuming that the server
does not respond. If the timeout expires and the server has not
responded, the switch queries the next RADIUS server in the list. If
there are no more servers, then the switch defaults to the standard
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
RADIUS Client Configuration
1 - Global Encryption Key ............. ATI
2 - Global Server Timeout period....... 10 second(s)
3 - RADIUS Server 1 Configuration ..... 0.0.0.0
4 - RADIUS Server 2 Configuration ..... 0.0.0.0
5 - RADIUS Server 3 Configuration ..... 0.0.0.0
6 - Show Status
R - Return to Previous Menu
Enter your selection?