Allied Telesis AT-S63 - Manual (Page 582)

Chapter 24: Multiple Spanning Tree Protocol
582 Section V: Spanning Tree Protocols
8. Enter the VLAN ID of the virtual LAN that you want to associate with
the MSTI ID. You can enter more than one VLAN at a time (for
example, 2,4,7) (To view VIDs, refer to “Displaying VLANs” on
page 621.)
The VLANs already associated with the MSTI ID are removed when
the new VLANs are added. The removed VLANs are returned to CIST.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Clearing VLAN
to MSTI
Associations
To clear VLAN to MSTI associations, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 177 on
page 535.
2. From the Spanning Tree Configuration menu, type 3 to select Configure
Active Protocol.
The MSTP menu is shown in Figure 194 on page 568.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 196 on page 573
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 197 on page
579.
5. From the VLAN-MSTI Association menu, type 4 to select Clear VLAN
to MSTI Association.
The following prompt is displayed:
Enter the MSTI ID: [1 to 15] ->
6. Type the MSTI ID number and press Return.