Allied Telesis AT-S63 - Manual (Page 804)

Chapter 34: PKI Certificates and SSL
804 Section VIII: Management Security
Modifying a Certificate
The procedure in this section modifies a certificate. (The certificate to be
modified must be in the certificate database.) Here are the certificate items
you can modify:
ˆ State - trusted or untrusted
ˆ Type - EE, CA, or Self
Note
These parameters have no affect on the operation of a certificate.
They are included only for informational purposes when the
certificate is displayed in the certificate database.
This procedure starts from the X509 Certificate Management menu. If you
are unsure how to access the menu, perform steps 1 to 4 in the procedure
“Adding a Certificate to the Database” on page 801.
To modify a certificate, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 86 on page 289.
2. From the Security and Services menu, type 7 to select Keys/
Certificates Configuration.
The Keys/Certificates Configuration menu is shown in Figure 264 on
page 771.
3. From the Keys/Certificate menu, type 3 to select Public Key
Infrastructure (PKI) Configuration.
The Public Key Infrastructure (PKI) Configuration menu is shown in
Figure 270 on page 798.
4. From the Public Key Infrastructure (PKI) Configuration menu, type 2 to
select X509 Certificate Management.
The X509 Certificate Management menu is shown in Figure 271 on
page 798.
5. From the X509 Certificate Management menu, type 4 to select Modify
Certificate.
The following prompt is displayed:
Enter a certificate name ->