Allied Telesis AT-S63 - Manual (Page 48)

Chapter 2: Starting a Management Session
48 Section I: Basic Operations
For information about the command line interface, refer to the AT-S63
Management Software Command Line Interface User’s Guide.
4. To use the menus interface, type menu and press Return.
The Main Menu is shown in Figure 3 on page 46.
To select a menu item, type the corresponding letter or number.
To return to the command line interface, type C.
When you press the Esc key or type the letter R in a submenu, the
previous menu is redisplayed.
Note
You cannot operate both a local management session and a remote
management session on the same switch simultaneously.
Quitting a
Remote
Management
Session
To end a remote management session, return to the Main Menu and type
Q for Quit.
Note
Failure to properly exit from a local or Telnet management session
may block future management sessions until the console timer times
out.
You should always exit from a management session when you are
finished managing a switch. This prevents unauthorized individuals from
making changes to a switch’s configuration if you leave your management
station unattended. For information about how to use the console timer to
automatically disconnect a management session, refer to “Configuring the
Console Timer” on page 72.