Allied Telesis AT-MCF2000M - Manual (Page 57)

AT-MCF2000M Management Module Installation Guide
57
Note
The port settings are for a DEC VT100 or ANSI
terminal, or an equivalent terminal emulator program.
Note
The prompt “Hit any key to stop autoboot,” displayed
on the console when the management module is reset
or power cycled, is for manufacturing purposes only
and should be ignored. If you inadvertently display the
manufacturing prompt (=>), type “bootapp” to launch
the management software on the management
module.
4. Press Enter.
You are prompted for a user name and password.
5. Enter a user name and password of a manager
account on the management module.
The module comes with a predefined manager account
that permits access to all the parameters on the
management and media converter modules. The user
name of this account is “manager” and the default
password is “friend.” User names and passwords are
case sensitive.
The local management session starts and the
command line interface (CLI) prompt is displayed, as
shown in Figure 21.
Figure 21. CLI Prompt
6. To test the management module and the installation,
enter this command:
system show cluster
The command lists all the devices in the stack. If the
chassis with the management module is not part of a
stack, the command displays just the devices of that
Allied Telesis AT-MCF2000M - AT-S97
#