Allied Telesis AT-MCF2000M - Manual (Page 56)

Chapter 2: Installation
56
Starting a Local Management Session
To start a local management session on the chassis or
stack, perform the following procedure:
1. Connect the DIN-8 connector on the RS-232
Serial Management cable included with the
AT-MCF2000M Management Module to the RS-232
Terminal port on the management module, as shown in
Figure 20.
Figure 20. Connecting the RS-232 Serial Management
Cable to the RS-232 Terminal Port
2. Connect the DB-9 connector on the RS-232 Serial
Management cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulation program
as follows:
ˆ Baud rate: 115200 bps (The baud rate of the
RS-232 Terminal port is adjustable from 9600 to
115200 bps. The default is 115200 bps. To adjust
the baud rate, refer to the AT-S85 and AT-S97
Management Software Command Line User’s
Guide.
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
1203a
AT-MCF
2000
M
STACK
MANAG
EMENT
TERMIN
AL
10/100 /1000 BASE-T
RS-232
RESET
SD
RDY
BUSY
MASTE
R
POWER
BOO T RDY
FAULT
1000 LINK
ACT
10/100 LINK
ACT
FDX HDX
COL
LINK
ACT
PORT A
CTIV ITY AT-MCF2KF
AN
NORMAL
FAULT
STATUS