Allied Telesis AT-MCF2000M - Manual (Page 47)

AT-MCF2000M Management Module Installation Guide
47
Installing the Management Module
Caution
The management module is sensitive to and can be
damaged by electrostatic discharge. Wear a
grounding device and observe electrostatic discharge
precautions when installing a management module in
the chassis.
Note
The AT-MCF2000M Management Module supports
hot swapping. You can install the module while the
chassis is powered on.
Note
This procedure uses the AT-MCF2000 chassis for
illustration purposes. Your chassis may be different.
To install the management module in the chassis, perform
the following procedure:
1. Using a cross-head screwdriver, loosen the two captive
screws that secure the blank panel over the
management slot and remove the panel from the
chassis, as shown in Figure 13 on page 48. Refer to
the chassis’ Installation Guide for the location of the
management slot.
Note
Do not remove the blank panel from the chassis until
you are ready to install a module. An open slot allows
dust to enter the unit and interferes with the chassis’
ability to maintain proper airflow and cooling.