Allied Telesis AT-MCF2000M - Manual (Page 51)

AT-MCF2000M Management Module Installation Guide
51
6. If the chassis will be part of a stack, Allied Telesis
recommends affixing a label with the chassis ID
number to the front of the unit. (Refer to “Setting the
Chassis ID Jumper” on page 45 for information on the
ID number.) The label should also include the chassis’
MAC address, found on the bottom panel of the device
or displayed with the AT-S97 Management Software.
Having this information on the front panel will make it
easier for you to identify the individual physical units of
the stack when you manage the media converters with
the management software.
This completes the initial installation of the AT-MCF2000M
Management Module. To complete the installation, do the
following:
ˆ To install additional modules in the chassis, refer to the
modules’ Installation Guide for instructions.
ˆ To create a stack of media converter units, refer to
“Cabling a Media Converter Stack” on page 52.
ˆ To verify the installation, refer to “Verifying the
Installation” on page 55.
ˆ To begin managing the chassis or stack, refer to
“Starting a Local Management Session” on page 56 or
the AT-S85 and AT-S97 Management Software
Command Line Interface User’s Guide.