Allied Telesis AT-MCF2000M - Manual (Page 42)

Chapter 2: Installation
42
Cable Requirements
10/100/
1000Base-T
Management
Port
Table 8 lists the cable requirements for the 10/100/
1000Base-T Management port. For background
information, refer to “10/100/1000Base-T Management
Port” on page 21. For port pinouts, refer to “10/100/
1000Base-T Management Port Pinouts” on page 68.
Note
The default setting for the Management port is Auto-
Negotiation with auto-MDI/MDI-X. In the default
setting, the port’s speed, duplex mode, and
MDI/MDI-X settings are set automatically.
Table 8. Cable Requirements for the 10/100/1000Base-T
Management Port
Speed Cable Type
Maximum
Operating
Distance
10 Mbps Standard TIA/EIA 568-B-
compliant Category 3 or
better shielded or
unshielded cabling with
100 ohm impedance and
a frequency of 16 MHz. 100 m (328 ft)
100 or
1000 Mbps Standard TIA/EIA 568-B-
compliant Enhanced
Category 5 (Cat 5e)
shielded or unshielded
cabling with 100 ohm
impedance and a
frequency of 100 MHz. 100 m (328 ft)