Samsung SEG-I717RWAATT User Manual
Page 53
Call Functions 48
•
Speaker: routes the phone’s audio through either the speaker or
through the earpiece.
–
Tap Speaker to route the audio through the speaker. (You can adjust
the speaker volume using the volume keys.) A green line will appear
under the Speaker button.
–
Tap Speaker again to use the phone’s earpiece (see “Using the
Speakerphone During an Active Call” on page 50.) The green line
will turn grey when Speaker is not activated.
•
Mute: turn the onboard microphone either on or off.
–
Tap Mute during a call to mute the microphone. A green line will
appear under the Mute button.
–
Tap Mute again to unmute the microphone. The green line will turn
grey when Mute is not activated.
•
Headset: connects to a Bluetooth headset.
–
Tap Headset during a call to activate a Bluetooth headset. A green line
will appear under the Headset button.
–
Tap Headset again to de-activate the Bluetooth headset. The green line
will turn grey when the Headset is not activated.
•
Press
for more options:
–
Contacts: allows you to go to your Contact list.
–
Memo: allows you to jot down a memo during a call.
–
Noise suppression on/off: allows you to turn on the Noise
Suppression feature when you are in a noisy area. Turn it Off when not
needed to conserve battery power.
Placing a Call on Hold
You can place the current call on hold at any point during a
conversation. You can also make another call while you have a
call in progress if your network supports this service.
1.
While on a call, tap Hold
. This action places the
current caller on hold (which is displayed on-screen as a
greyed-out box).
2.
You can later reactivate this call by tapping Unhold.
To make a new call while you have a call in progress
1.
Tap Hold
.
2.
Tap Add call
to display the dialer.
3.
Enter the new number and tap
.
Once connected, the active call will appear in a large box
in the middle of your screen and the call on hold will
appear in a small box in the upper right corner of your
screen.
Switching Between Calls
When you have an active call and a call on hold, you may switch
between the two calls, changing the one on hold to active and
placing the other on hold.