Samsung ER-GX20ZBBB-E1 - Manual (Page 53)

052
Remote Control Shooting (Sold Separately)
You can set the remote control function in the drive mode menu.
(sold separately)
• [Remote Control] : The shutter will be released immediately the shutter release
button on the remote control unit is pressed.
• [Remote Control (3s delay)] : The shutter will be released 3 seconds
after the shutter release button on the
remote control unit is pressed.
• [Remote Control (continuous)] : The continuous shooting starts as soon as
you press the remote control unit.
Press the remote control unit one more
time to fi nish shooting.
1. Press the Fn button on your camera and
then press the direction button (▲).
- The drive mode screen appears.
2. Press the direction buttons (◄►) to select
, or .
- The self-timer lamp will blink to let you know
that the camera is in remote control wait
status.
3. Press the OK button.
- The camera is ready to take pictures.
4. Press the shutter release button halfway.
- The autofocus system operates. The focus indicator ( ) appears in the
viewfi nder when the subject is in focus.
5. Point the remote control unit towards the
front of the camera and press the shutter
release button on the remote control.
The picture is taken.
● You cannot focus with the remote control unit in default settings. Focus
on the subject fi rst before operating with the remote control. You can
set [AF in Remote Control] to [On] in the [CUSTOM1 MENU] menu.
● Turn the power off to stop the remote control operation after it has
been activated.
● The remote control may not operate in backlit conditions.
● To take a picture while charging the built-in fl ash, set [Release in
Charging] to [On] in the [CUSTOM2 MENU].
● When using the built-in fl ash, raise the fl ash into position fi rst.
Remote Control
Drive
: Set : Move
Single Frame Shooting
Drive
: Set : Move