Samsung ER-GX20ZBBB-E1 - Manual (Page 25)

024
Attaching and removing the lens
For additional use of lenses, please check lenses available to be used at
Customer Service.
Some functions are restricted when lenses are not set
to Aperture A (Auto). To allow shutter release, set [Use Aperture Ring] in
[CUSTOM2 MENU] menu.
Turn the camera off before attaching or removing the lens to prevent
unexpected lens problems.
1. Check that the camera is off.
2. Remove the body mount cover (①) and
lens mount cover (②). Be sure to put the
lens down with the lens mount side facing
upward to avoid damage.
3. Align the red dots on the camera and the
lens, and secure by turning the lens
clockwise until it clicks. After attaching,
check that the lens is secure. Also check
that the red dots of the lens are on top
and the attached portion does not move
sideways.
4. Remove the front lens cap by pushing the
indicated portions inward.
5. To detach the lens, hold down the lens
unlock button (③) and turn the lens
counterclockwise.
● The body mount cover ( ① ) is a cover to prevent damage during
shipping.
● We assume no responsibility nor liability for accidents, damages and
malfunctions resulting from the use of lenses made by other manufac-
turers.
● The camera body and lens mount incorporate lens information
contacts and an AF coupler. Dirt, dust, or corrosion may damage the
electrical system. Clean the contacts with a soft dry cloth.
Attaching and removing the lens must be done in a clean place. Please
avoid contact with liquid water. If the camera’s body or the lens gets wet or
dirty, camera malfunction may occur.