beautypg.com

Using the built-in flash, Compensating flash output, Flash characteristics in each exposure mode – Samsung ER-GX20ZBBB-E1 User Manual

Page 103

background image

102

Compensating Flash Output

You can change the fl ash output in a range of -2.0 to +1.0. The Flash
Compensation values are as follows for 1/2 EV and 1/3 EV.

Step interval

Flash Compensation

1/2 EV

-2.0, -1.5, -1.0, -0.5, 0.0, +0.5, +1.0

1/3 EV

-2.0, -1.7, -1.3, -1.0, -0.7, -0.3, 0.0, +0.3, +0.7, +1.0

Set interval of steps in [EV Steps] in the [CUSTOM1 MENU] menu.

h Using the rear dial (

), adjust the

compensating fl ash output in the Fn menu >
[FLASH].

blinks in the viewfi nder when the fl ash pops up during Flash

Compensation.

● Compensating fl ash output is not available while using the (Auto mode).
● If the maximum fl ash output is exceeded when corrected to the plus (+)

side, no compensation will be effective.

● Compensating to the minus (-) side may not effect the image if the subject

is too close, aperture is low or sensitivity is high.

Using the Built-in Flash

Flash Characteristics in Each Exposure Mode

Using the Flash in Tv (Shutter Priority) Mode

- When taking a moving subject, you can use the fl ash to change the blur

effect.

- Within the shutter speed limit of “1/180” sec or slower, you can use the built-in

fl ash for shooting.

- The aperture value automatically changes according to the ambient

brightness.

■ Using the Flash in Av (Aperture Priority) Mode

- You can set the desired aperture to take a fl ash photograph when you want

to change the depth of fi eld or shoot a subject farther away.

- The shutter speed automatically changes with the ambient brightness.
- The shutter speed shifts automatically anywhere from 1/180 sec. to a slow

shutter speed that reduces camera shake. The slowest shutter speed

depends on the focal length of the lens in use.

Fill-In + Red-eye

FLASH

: Set

This manual is related to the following products: