Horner APG QX651 OCS - Manual (Page 41)

MAN0798-04-EN CH. 9
August 20, 2009 Page 41 of 95 ECN # 979
CHAPTER 9: SYSTEM SETTINGS AND ADJUSTMENTS
9.1
System Menu - Overview
The QX controller has a built-in System Menu, which lets the user view System Settings and make
adjustments. To start the System Menu, press the SYSTEM keys at the same time (or set %SR3 to 1),
which will display the Main Menu, as shown in Figure 9-1. Then use the
↓ and ↑ keys to select a Main
Menu item and press Enter to display the item’s Sub-Menu.
Figure 9-1 – System Menu
Network Ok? Yes
Network ID: 253
Network Baud: 125 KB
( Use
↓↑ to adjust )
Contrast:
( No Adjustment )
( on this model )
Sub-Menus
Model: QX451
OR
Model: QX451BP43
OCS Mode: Idle
Scan Rate(mS): 0.0
OCS Net Use(%): 0.0
All Net Use(%): 0.0
Ladder Size: 2
Config Size: 8
Graphics Sz: 8
String Size: 8
Bitmap Size: 8
Text Tbl Size: 8
Font Tbl Size: 8
Protocol Size: 8
Firmware Rev: 11.76
BIOS Rev: 0.12
FPGA Rev: 2.8
Self-Test: Ok
Logic Error: Ok
User Program: Ok
User Graphics: Ok
W-Dog Trips: 0
Net Errors: 0
Network State: Ok
Network ID: Ok
Dup Net ID: Ok
Clock Error: Ok
I/O System: Ok
Battery:
Ok
Base Selected: CPU
Base Online? Yes
Slot 1:+I/O: FOX100
Slot 2:+I/O: ETN300
Slot 3:+I/O: HSC501
Slot 4: I/O: Empty
Set Network ID
Set Network Baud
Set Contrast
View OCS Status
View OCS Diags
View I/O Slots
View Protocols
Set Fkeys Mode
Set RS232 Mode
Set Time/Date
Set Beeper
Set Screen
Removable Media
Fail-Safe System
Clone Unit
(ESC to Exit)
Main Menu
Port 1:
(None Loaded)
Port 2:
(None Loaded)
Port 3:
(None Loaded)
Sub-Menus
Fkeys: Momentary
Sys-Fn enable: Yes
( Use
↓↑ to adjust )
RS232 Mode: CsCAN
( Use
↓↑ to adjust )
Time: 10:21:36
Date: 22-Jun-2006
Day: Thursday
( Use
↓↑ to adjust )
( each field )
Saver enable: No
Timeout(min): 15
Popup Status: Off
Update Time(mS): 5
Update time sets
the maximum time
used by graphics
in the logic scan.
Media Directory
Media Card Not Present
Note: The QX display
shows up to 15 lines of text at a
time. For System Menu
screens that contain more than
15 lines of text, use the
↓ and ↑
Beeper enable: Yes
( Use
↓↑ to adjust )
Base Selected: CPU
Base Online? Yes
Slot 1:+I/O: ETN300
Slot 2: I/O: Empty
Slot 3: I/O: Empty
Slot 4: I/O: Empty
or
Backup/Restore Data
Enable AutoRun
Enable AutoLoad
(ESC to exit)
Clone Unit
Directory Empty