3 zfi camera settings menu, 1 zone titling menu – Videotec ULISSE User Manual

Page 31

EN - English - I

nstruc

tions manual

ZONE TITLING

------------------------

1>NR. : 1

2 ENAB.: N

3 START: + 0.00

4 STOP : + 0.00

5 TEXT : ZONE 1

Fig. 62

Example: To enable titling of zone 1 when the device
is between +15° and +45°, it is necessary to:
• Enable area titling by setting Y as the value of

Enabling.

• Set 1 as the value of parameter Nr.
• Set +015.00 as the value of parameter Start.
• Set +045.00 as the value of parameter Stop.
• If necessary, edit the displayed text by selecting

Text.

Setting the Start and Stop values of the
menu to zero will disable text display. If
there are overlapping areas, the area with
the lowest number will prevail.

To define zones proceed in a clockwise
direction, as shown in the figure.

0°

Start1=15°

Stop1=45°

Start2=170°

Stop2=225°

270°

90°

180°

Fig. 63

9.6.3 ZFI camera settings menu

01. Zoom: This sets the maximum zoom level that

the motorised lens can achieve.

02. Common Wire: If enabled, it manages the

motorised common wire lenses; if disabled, it
manages those with inversed polarity.

04. Area Titling: Allows access to the area titling

submenu.

05. Zone Masking: This provides access to the zone

masking management submenu.

06. Housing Serial Port: Allows access to the

submenu for managing the housing serial port.

07. Polarity: Allows access to the submenu for

managing the polarity of the Zoom, Focus and
Iris motors.

ZFI CAMERA SETTINGS

------------------------

1>ZOOM : 30x

2 COMMON WIRE : N
4 ZONE TITLING >

5 ZONE MASKING >

6 HOUSING SERIAL PORT >

7 POLARITY >

Fig. 61

9.6.3.1 Zone titling menu

This function allows setting up to 8 areas (variable
dimension) with titling option.
From the Zone Titling menu it is possible to set the
following parameters:
01. Number: Selects the area to be edited.
02. Enabling: Enables the message linked to the

related zone to be displayed on the screen.

03. Start: Sets the initial position of the area.
04. Stop: sets the final position of the area.
05. Text: Modifies the text which is displayed when

moving within the zone.