3 module 3 - d, Isplay, Rogram – Red Lion PAXDR User Manual
Page 15: Arameters
15
15
6.3 MODULE 3 - D
ISPLAY
AND
P
ROGRAM
L
OCK
-
OUT
P
ARAMETERS
(
)
3-LOC
SP-n
COdE
Totalizer x
Display
Lockout
Totalizer x
Scale Factor
Access
Totalizer A
Count Load
Access
rAtE
Rate x
Display
Lock-out
PAR
tot
ACntLd
SCFAC
Pro
Setpoint 1-4
Access
Security
Code
x
x
x
Totalizer B
Count Load
Access
bCntLd
PARAMETER MENU
x = Rate or Totalizer A, B, and then C
= Setpoints 1 to 4
Module 3 is the programming for Display lock-out and “Full” and “Quick”
Program lock-out.
When in the Display Mode, the available displays can be read consecutively
by repeatedly pressing the DSP key. An annunciator indicates the display being
shown. These displays can be locked from being visible. It is recommended that
the display be set to
when the corresponding function is not used.
SELECTION
DESCRIPTION
Visible in Display Mode
Not visible in Display Mode
“Full” Programming Mode permits all parameters to be viewed and
modified. This Programming Mode can be locked with a security code and/or
user input. When locked and the PAR key is pressed, the meter enters a Quick
Programming Mode. In this mode, setpoint, count load and scale factor values
can still be read and/or changed per the selections below. The Display Intensity
Level () parameter also appears whenever Quick Programming Mode is
enabled, and the security code is greater than zero.
SELECTION
DESCRIPTION
Visible but not changeable in Quick Programming Mode
Visible and changeable in Quick Programming Mode
Not visible in Quick Programming Mode
RATE A B C DISPLAY LOCK-OUT
TOTALIZER A B C DISPLAY LOCK-OUT
These displays can be programmed for
or
.
The setpoint values can be programmed for
,
, or
. Accessible
only with a Setpoint Plug-in card installed.
SETPOINT 1 to 4 ACCESS LOCK-OUT
to
Count Load values can be programmed for
,
, or
.
TOTALIZER A and B COUNT LOAD ACCESS LOCK-OUT
The Scale Factor values can be programmed for
,
, or
.
TOTALIZER A B C SCALE FACTOR ACCESS LOCK-OUT
Entry of a non-zero value will cause the prompt
to appear when trying to
access the “Full” Programming Mode. Access will only be allowed after entering
a matching security code or universal code of
. With this lock-out, a user input
would not have to be configured for Program Lock-out. However, this lock-out is
overridden by an inactive user input configured for Program Lock-out.
SECURITY CODE
PROGRAMMING MODE ACCESS
Throughout this document, Programming Mode always refers to “Full” Programming (all meter parameters are accessible), unless “Quick
Programming” is referenced.
SECURITY
CODE
USER INPUT
CONFIGURED
USER INPUT
STATE
WHEN PAR KEY IS
PRESSED
“FULL” PROGRAMMING MODE ACCESS
0
not
————
“Full” Programming
Immediate access.
>0
not
————
Quick Programming w/Display Intensity
After Quick Programming with correct code # at
prompt.
>0
Active
Quick Programming w/Display Intensity
After Quick Programming with correct code # at
prompt.
>0
Not Active
“Full” Programming
Immediate access.
0
Active
Quick Programming
No access
0
Not Active
“Full” Programming
Immediate access.