Vaisala HMP228 - Manual (Page 62)

HMP228 Transmitters
Appendix 1: Serial commands
M210282en-A
56
FTIME Adding time to output
FTIME xxx
xxx = ON or OFF
When FTIME is activated, the current time is output at the beginning of the
output line. The time is set with command TIME. After RESET or power on
the current time is 00:00:00.
Activating the time output
>ftime on
Form. time : ON
>intv 5 s setting the output interval
Output intrv. : 5 s
>r
09:31:13 aw= 0.195 T= 26.0 'C
09:31:18 aw= 0.195 T= 26.0 'C
09:31:23 aw= 0.195 T= 26.0 'C
09:31:28 aw= 0.195 T= 26.0 'C
09:31:33 aw= 0.195 T= 26.0 'C
09:31:38 aw= 0.195 T= 26.0 'C
...
Inactivating the time output
>ftime off
Form. time : OFF
>r
aw= 0.196 T= 26.1 'C
aw= 0.196 T= 26.1 'C
aw= 0.196 T= 26.1 'C
aw= 0.196 T= 26.1 'C
aw= 0.196 T= 26.1 'C
aw= 0.196 T= 26.1 'C
...
FDATE Adding date to output
FDATE xxx
xxx = ON or OFF
When FDATE is activated, the current date is output at the beginning of the
output line. The time is set with command DATE. After RESET or power on
the current date is 1991-01-01.