Vaisala HMM100 - Manual (Page 50)

User's Guide _______________________________________________________________________
48 ___________________________________________________________________ M211024EN-C
Connecting to the Module in POLL Mode
Use the OPEN command to connect to a module that is in POLL mode.
OPEN [aa]
where
aa
= address (0 ... 99)
Example:
>open 1
HMM100: 1 line opened for operator commands
>
Closing the Connection in POLL Mode
The CLOSE command closes the connection to the module.
CLOSE
Example:
>close
line closed
>
Save Changed Settings
Use the SAVE command to save changed settings to the module
memory. Most settings have to be saved or the changes are lost at the
next reset or power down.
NOTE The SMODE command saves the new serial mode immediately;
a separate SAVE command is not needed.
SAVE
Example:
>save
Saving settings...done
>