Vaisala HMM100 - Manual (Page 34)

User's Guide _______________________________________________________________________
32 ___________________________________________________________________ M211024EN-C
Show Quantities
The CALCS command shows the abbreviations of the quantities
measured by HMM100:
CALCS
Example:
>calcs
RH Td T
>
Show Calibration Info
Use the CALINFO command to show or set the calibration info field.
CALINFO ["location"]
Examples:
>calinfo
Calibration location: "VAISALA HELSINKI"
>
>calinfo "Calibration lab 2"
Calibration location: "Calibration lab 2"
>
Show Analog Output Status
The STATUS command shows the following information:
- Current analog output state (ON for normal, ERROR if an error is
active)
- Status of analog channel error notification (ON for enabled, OFF for
disabled). See section Analog Output Error Notification on page 61.
- Scaling of the selected output quantity (low and high values)
- Error notification level for the current analog output mode
STATUS [notification] [level]
where
notification = If specified, enables or disables the analog output
error notification. Allowed values ON and OFF.
level = Error notification level. Allowed values are 0 … 30.