Outback Power Systems VFX Series Programming Manual - Manual (Page 32)

31
ADV/FX/STACK------------P02
stack OB Slave L1
phase
DOWN INC DEC PORT
OutBack (OB) SLAVE L2
• Set the FX’s you want as series Slaves (Leg 2) to OB Slave L2.
• This FX is considered the L2 phase.
To use OutBack Slave L2 stacking, press in
the ADV/FX/STACK OB screen to change the stack
phase from OB Slave L1 to OB Slave L2.
ADV/FX/STACK----------P02
stack OB Slave L1
phase
DOWN INC DEC PORT
ADV/FX/STACK----------P02
stack OB Slave L2
phase
DOWN INC DEC PORT
The FX assigned to Port 02 now has OB Slave L2
status.
ADV/FX/STACK-----------P01
stack 1-2 ph Master
phase
DOWN INC DEC PORT
A 3-phase system with only three FXs requires
one of two diff erent stacking procedures. Starting
from the fi rst stacking menu—ADV/FX/STACK—
press four times.
Press four times
3-Phase (3ph) Master
OB Slave 1 stacking phase
INC
INC