2ph master, Outback (ob) slave – Outback Power Systems VFX Series Programming Manual User Manual

Page 31

1-2ph Master

With the Port 01 FX as the Master, press the soft key to change the remaining Ports and

designate the remaining FXs as Slaves. The MATE screen for Port 02 will look like this:

ADV/FX/STACK---------P02

stack 1-2ph Master

phase

DOWN INC DEC PORT

The MATE is now ready to program the FX plugged

into Port 2 of the HUB.

1-2ph Master is the factory default value for each

ADV/FX/STACK---------P02

stack 1-2ph Master

phase

DOWN INC DEC PORT

Pressing will keep the MATE’s

attention on Port 2, but will change the stack

phase to Classic Slave screen. Port 02 will then be

assigned as a Classic Slave. You can change the

stacking phase by pressing or

and change to a diff erent Port by continuously

pushing .

NOTE

There are no or commands in the stacking menu. Whichever value—Master or

Slave—shows up on the MATE screen will be assigned to the chosen Port (and FX) upon leaving that
screen. It’s important to watch the Port number in the top right corner of each screen to be sure you’ve
assigned it the desired status.

Systems with two to ten FXs call for OutBack

Slave Stacking. Press in the ADV/FX/

STACK screen to change the stack phase from

Classic Slave to OB Slave L1.

ADV/FX/STACK-----------P02

stack Classic Slave

phase

DOWN INC DEC PORT

OutBack (OB) Slave

INC

DEC

PORT

INC

This manual is related to the following products:

FX Series Programming Manual